Inspect, Reverse-Design, and Verify Every Part
From first-article inspection to recreating tooling without drawings, we bring dimensional scanning and inspection to your shop floor — so parts, fixtures, and tooling are measured, modelled, and verified against spec.
Where 3D scanning pays off in manufacturing
Reverse design
Recreate parts, tooling, and fixtures with no drawings — scan the original and get a clean, manufacturable CAD model.
First-article & in-process inspection
Verify that machined and fabricated parts match spec, with full dimensional reports.
Tooling & fixture recovery
Rebuild worn jigs, dies, and fixtures to accurate geometry before they fail completely.
Quality & QC documentation
Colour-mapped deviation reports that show exactly where a part drifts from nominal.
What you walk away with
Registered point cloud & mesh
A precise digital capture of the part or tool you can measure any time.
Manufacturable CAD models
Parametric, production-ready models for machining, casting, or fabrication.
Reverse-designed geometry
Undocumented parts rebuilt to accurate, tolerance-aware models.
Inspection reports
Dimensional comparison against CAD or a reference, with deviation maps.
How a scan project works
On-site scan
We scan your part, tool, or fixture on the shop floor and capture its exact geometry.
Register & process
We stitch the scans into one accurate, measurable point cloud.
Model & deliver
We turn the data into the exact CAD model your project needs.
Why manufacturers work with Creative GOAT
Creative GOAT supports manufacturing and fabrication projects where the physical asset exists but the information needed to reproduce, modify or verify it does not. The starting point may be a worn component, a modified assembly, an obsolete fixture or an existing interface that no longer has a dependable drawing or model.
We capture the relevant visible geometry and develop purpose-built CAD models, drawings and dimensional comparison information for the required task. Depending on the scope, this may support reverse modelling, replacement-part development, fixture or tooling documentation, equipment modification, fit-up planning or comparison of a fabricated assembly with its design model.
The capture and modelling approach is selected according to what the information must support next. Critical interfaces, inaccessible features, assumptions and verification requirements are defined within the agreed scope.
Where fabrication is included, Creative GOAT can coordinate and supply one-off or low-volume parts and assemblies from the defined design information. The objective is a clear handoff from the physical asset to the people responsible for design, machining, fabrication or installation.
Got a part or tool that needs measuring or modelling?
Send us the component, and we will scan, inspect, or reverse-design it — and hand back the model or report your shop needs.